A tap that coughs air or drips a trickle after a hard cold night usually means ice is blocking a pipe somewhere between the meter and that fixture. The pipe may not have split yet. How you thaw it decides whether it does.
Safe ways to thaw
- Open the affected faucet, hot and cold, so melting water has somewhere to go and pressure does not build behind the ice.
- Find the cold spot. Look at pipes in exterior walls, under sinks on outside walls, in crawlspaces, garages and attics.
- Apply gentle heat: a hair dryer, a space heater kept well back from anything that can burn, or towels soaked in hot water. Open cabinet doors so room heat reaches the pipes.
- Never use a torch, propane heater or open flame. It can start a fire inside the wall or flash steam inside the pipe.
Keep the heat on until full pressure returns. If you cannot find or reach the frozen section, or water starts appearing somewhere new as the ice melts, close the main shut-off right away. A split often hides until the ice that was plugging it thaws.
What a plumber does
Plumbers use pipe-thawing machines that pass low-voltage current through metal pipe, or heat cable and warm air for plastic. After thawing, they pressure-check the line, replace any section that cracked, and look at why it froze in the first place. Common fixes in Ruby, AK homes include insulating the run, sealing a draft from a rim joist or vent, rerouting a line away from an outside wall, or adding thermostatically controlled heat cable to a pipe that cannot be moved.
